Introduction to VTP (VLAN Trunking Protocol)

VLAN Trunk Protocol (VTP) reduces administration in a switched network. When you configure a new VLAN on one VTP server, the VLAN is distributed through all switches in the domain. This reduces the need to configure the same VLAN everywhere. VTP is a Cisco-proprietary protocol that is available on most of the Cisco Catalyst series … Continue reading Introduction to VTP (VLAN Trunking Protocol)

Configure CheckPoint Firewall to use LDAPS

Before continuing with this guide you must first enable LDAPS in your environment. So after we enable LDAPS we can continue..... connect to your Smart Console. 2. Go to your "Gateway Properties" 3. Locate "Identity Awareness" and click on Active Directory Query Settings. 4. Click on "Servers" Tab, Select LDAP host and then Click on … Continue reading Configure CheckPoint Firewall to use LDAPS

Configure Netflow on Cisco Catalyst WS-C3650-48PD

DR-Switch(config)# flow record record-1 match ipv4 protocol match ipv4 source address match ipv4 destination address match transport source-port match transport destination-port match transport icmp ipv4 type match transport icmp ipv4 code match flow direction collect transport tcp flags collect counter bytes long collect counter packets long!!DR-Switch(config)#flow exporter exporter-1 destination X.X.X.X source VlanX transport udp 9996!!DR-Switch(config)# … Continue reading Configure Netflow on Cisco Catalyst WS-C3650-48PD